|
10BaseT Cabling
When
10BaseT cabling is used, a strand of cabling is inserted
between each computer and a hub. If you have 5 computers,
you'll need 5 cables. Each cable cannot exceed 325 feet in
length. Because the cables from all of the PCs converge at a
common point, a 10BaseT network forms a star configuration,
or geometric design, when viewed from above. In the figure
below, three computers are connected together with 10BaseT
cabling and a hub.
A
10BaseT hub is basically a box with a row of 10BaseT jacks.
Most hubs have 5, 8, 12, or 16 jacks, but some may have
more. Most hubs also have an uplink port, which is a special
10BaseT or thin coax port that allows the hub to be
connected to either (1) other hubs, or (2) a thin coax
backbone (see below for information on backbones). By
up-linking multiple hubs together, you can add additional
computers to your network whenever you need to.
10BaseT cabling is available in different grades or
categories. Some grades, or "cats", are required for Fast
Ethernet networks, while others are perfectly acceptable for
standard 10Mbps networks--and less expensive, too.
About 85% of the networks in the U.S. use standard
unshielded twisted-pair (UTP) Category 5 10BaseT cabling
because it offers a performance advantage over lower grades.
If you are using a 10Mbps network, category 3 is fine. If
you plan on building a Fast Ethernet network at some time in
the future, it's best to install Category 5 cabling.
10BaseT
Category What It's Used For
5
Fast Ethernet (and everything below)
4
Networks other than Ethernet
3
10Mbps 10BaseT
2
Alarms, telephone voice lines
1
Unknown (not rated for anything specific)
If
possible, decide whether you'll be using standard Ethernet
or Fast Ethernet technology before you begin building your
network. If you're not sure which technology you'll
eventually use, choose to install Category 5 cabling.
Remember, Fast Ethernet network adapters and hubs are not
directly compatible with each other. It is possible to have
both 10Mbps and 100Mbps segments on the same network,
provided you have a switching hub between them that allows
them to communicate.
|