|
Installing Windows 95/98
Windows 95/98 Installation Guide - Phase 1
Note
If you are installing
Windows 95,
it will be necessary to boot your PC using the supplied
floppy disk, then select 'Install Windows from CD-ROM' from
the menu that appears.
The procedure for installing
Windows 95/98
onto a new PC is as follows:
Switch on the PC and put the
Windows 95/98
CD into the CD-ROM. Press the reset button on the PC and
allow it to boot.
The PC should boot to the CD-ROM, if not check your
motherboard manual to enable 'Boot to CD-ROM' in its BIOS
settings.
From the next menu, select
Start Windows 98 setup
from the CD-ROM
The system will load some basic software to enable it to
install
At the blue
Windows 95/98 Setup screen, press
ENTER to
continue.
The system will check the HDD to determine if/how it is
configured
Select Configure
unallocated space (recommended) and press
ENTER
The system will 'Partition' the hard disk such that it can
prepare it for storing data
If prompted, select
Yes, enable large disk
support and press
ENTER
This enables the system to use the maximum space possible on
the hard disk
At the Setup will
restart now screen, press
ENTER or wait
and the system will automatically reboot
Phase One of the installation is complete and the system
needs to reboot to continue...
|